Manual setting tool for drop-in anchors (HDI-L/HDI/HDI-S/HDV) Share. Share on Facebook. Share on Twitter. Share on Email. Features & Applications. Features & Applications. Hand setting tool HST 3/8" #32979. Features. Simple, efficient hand tools to help you set Hilti drop-in anchors quickly and correctly. Using the designated Drop-In setting tool, drive expander plug towards the bottom of the anchor until the shoulder of the setting tool makes contact with the top of the anchor. When properly set, four indentations will be visible on the top of the anchor indicating full expansion.
Red Head 3/8 in. Solid DropIn Anchor Setting Tool07499 The Home Depot
DEWALT 1/4 in, 3/16 in Internal Dia. DropIn Anchor Setting Tool Set, Uses 3/16 in and 1/4 in
Hilti 1/4 in. Hand Setting Tool for DropIn Anchors3512350 The Home Depot
Dropin anchor buckets lipped anchors with drill bits & setting tool
DropIn Anchor Setting Tool Trutek™
HDIS Dropin anchor Mechanical Anchors Hilti USA
Drop In Anchor Setting Tool Setting Tool for Drop in Anchor dean&wood the face of
Drop In Anchor Setting Tool OZSTRUT
Red Head 3/8inch Solid DropIn Anchor Setting Tool 1 Pack The Home Depot Canada
Powers SDS plus dropin anchor drill bits with setting tool
Drop In Anchor Setting Tool Thomas Graham
Drop In Anchor Setting Tool OZSTRUT
UltraDrop Drop In Concrete Anchors Masonry Anchors
Dewalt Dropin Anchor Setting Tool, Steel PFM2101720 Zoro
DEWALT ENGINEERED BY POWERS 1/4 in Internal Dia. DropIn Automatic Anchor Setting Tool, Uses
1/4" wejit DropIn Anchor Setting Tool Mutual Screw & Supply
Drop In Anchor Setting Tool Abrafast
Olympic Fixings M12 Drop In Anchor Setting Tool (127321020) CEF
Hilti dropin anchor system 20160124 Plumbing and Mechanical Plumbing & Mechanical
%402x.jpg "Drop In Anchors (Lipped) Setting Tool ICCONS")
Drop In Anchors (Lipped) Setting Tool ICCONS
5/8''. 1. AT75. 3/4'' Drop-In Anchor Setting Tool. 3/4''. 1. 10. The AT Tool is needed to properly install and set all Drop-In Anchors from L.H Dottie. The anchor is properly expanded when the end of the setting tool is flush with the top of the anchor.. To install, insert the anchor cone end first and use an installation tool to drive the sleeve over the cone. Then, insert a screw or threaded rod and tighten. Pull-out strength and shear strength values are 25% of the ultimate values. For technical drawings and 3-D models, click on a part number. Anchors.
